Signature Series Handrail Hinge for Stair Corners | Black Finish

Handrail hinges are used to transition your handrail from a level run to an angled (or stair) run without needed complex bevel cuts. For standard transitions from a level to stair run, use a Stair Transition hinge. To end your handrail after a stair run use a Stair End hinge. If you have an inside corner right before your stair run, use a Stair Corner hinge.

Level III anodizing, or Type III hardcoat anodizing, is a process that creates a thick, highly wear-resistant, and corrosion-resistant oxide layer on aluminum. This is achieved through an electrochemical process that converts the aluminum surface into aluminum oxide using sulfuric acid and a controlled electrical current.

Cleaning anodized components is easy.

Use a Neutral Cleaner: Use mild dish soap or detergent with a pH between 6 and 8. Avoid acidic or alkaline cleaners, as they can damage the anodized coating.

Test a Small Area First: Before full application, clean a small, inconspicuous spot to ensure the cleaner doesn't cause discoloration or damage.

Clean Thoroughly and Rinse: Use a soft sponge or non-scratch cloth to clean the surface, ensuring all areas are addressed to prevent contaminant buildup. After cleaning, rinse thoroughly with water to remove any residue.

The Type III anodized aluminum finish can last over 20 years, depending on environmental conditions and wear. Coastal and high-UV environments may accelerate wear compared to inland or interior applications.